I. First, check the power supply.
Check the main power supply: Use a multimeter to measure the voltage at the power plug, such as 220V AC or 24V DC, and see if it matches the nominal value. If the voltage is incorrect, it may be a problem with the upstream circuit, such as a tripped circuit breaker or poor socket contact.
Test the power supply to a single floor: If only the lights on a certain floor are not working, measure the voltage from the control module to the light socket on that floor. If there is no output, it may be that a branch circuit is broken, a fuse is blown, or the control module circuit is faulty.
II. Next, check the bulbs and LEDs.
Visually inspect the LEDs: Check if the LEDs on the non-working floor are blackened or broken. If an LED is burnt out, there may be black spots on its surface.
Measure the resistance of the LEDs: Use a multimeter to measure the resistance across the two ends of the LED. Normally, it should conduct. If it shows infinite resistance, the LED is faulty.
III. Check Wiring and Connections
Check for Damage to Wiring: Carefully inspect power and control wires for breaks or short circuits, especially at frequently bent points.
Check for Secure Connections: Gently wiggle the connecting wires to check for looseness or poor contact. If a wire is broken, replace it with a wire of the same specification and reconnect it securely.
IV. Finally, Check the Control Module
Test Signal Functionality: For signal-controlled lights, such as those triggered by a PLC or switch, check for pulses in the control signal and whether the switch contacts are closed.
Short-Circuit Test: If you suspect a fault in a specific circuit of the control module, short-circuit that circuit to test if the light illuminates. If it illuminates, the problem likely lies with the module itself.
V. Other Precautions
Safety First: Always disconnect the power before troubleshooting to avoid electric shock.
Regular Maintenance: Regularly clean the lampshade and light board to maintain heat dissipation and lighting performance; ensure stable voltage to avoid excessive fluctuations that could burn out the LEDs.

