I. Regular Inspections are Essential
Visual Inspection: Before and after each use, check the tower for damage, deformation, or corrosion. Ensure connections such as flanges, bolts, and nuts are tight. Check for peeling or damage to the surface coating.
Electrical System Inspection: Check power cords for damage, short circuits, or poor contact. Ensure all electrical components in the control box are functioning properly. Check the motor for smooth operation and any abnormal noise or vibration.
II. Proper Cleaning and Lubrication are Crucial
Cleaning and Maintenance: Use a clean, damp cloth or soft brush to remove dust, dirt, and debris. After cleaning, apply rust-preventive oil or protective wax.
Lubrication and Maintenance: Regularly apply lubricating oil or grease to transmission parts such as lead screws, nuts, and gears. Be careful not to apply too much.
III. Safe Operation Must Be Remembered
Installation and Disassembly: Always follow safe operating procedures, wear necessary protective equipment, and ensure personal safety and the safety of surrounding workers.
Storage Environment: Store in a dry, well-ventilated room free of corrosive gases. Pack properly to its minimum length.
IV. Timely Troubleshooting
Simple Faults: Problems such as poor power cord contact or malfunctioning buttons can be repaired by yourself.
Complex Faults: For issues such as motor damage or controller malfunction, always contact the manufacturer's after-sales service. During repairs, strictly follow the procedures and use qualified tools and parts.
V. Other Precautions
Cable Allowance: When installing two cables, leave 15-20cm of slack outside the vehicle body to prevent stress on the cables when the boom is raised or lowered.
Turning Off Lights: After use, turn off the lights first. When restarting the lights, wait approximately 20 minutes for the bulbs to cool completely before restarting.

